Table of Contents
Advertisement
Suunto EON Steel
Deepstops activate when you dive deeper than 20 m (65.6 ft). Deepstops are presented like
safety stops. You are in the deepstop area when the deepstop depth has up/down arrows in
front of it and deepstop time is running.
NOTE: For safety reasons, you cannot switch off deepstops if helium (trimix gas
mixtures) is enabled for the dive mode in use.
3.27. Sample rate
Suunto EON Steel uses a fixed sample rate of 10 seconds for all log recordings.
3.28. Standby and deep sleep
Standby and deep sleep are two functions that are designed to prolong battery life. Standby
is an adjustable mode that turns off the screen after a set amount of time if Suunto EON Steel
is not used.
To adjust the standby time:
1. Keep the middle button pressed to enter the menu.
2. Browse to General » Device settings » Standby.
3. Press the middle button to enter Standby.
4. Scroll up/down to select the desired standby time in minutes.
5. Press the middle button to save changes and return to the Device settings menu.
6. Keep the middle button pressed to exit.
Deep sleep
Deep sleep is a function that prolongs battery life when Suunto EON Steel has not been used
for some time. Deep sleep is activated when two days have passed since:
No buttons have been pressed
•
Suunto EON Steel has been attached to PC/charger
•
Dive calculation has ended
•
Suunto EON Steel wakes up when it is connected to a PC/charger, when a button is pressed,
or when the water contact gets wet.
30
Advertisement
Table of Contents
