Suunto EON STEEL 1.2 Quick Manual

PARTS 1. GET STARTED
(1) (2)
1. Wake up the device by connecting the
USB cable.
2. Follow the start up wizard to set up
the device. When ready, the device
goes to Surface mode.
(3) (4)
3. Fully charge before first dive.
(1) Suunto EON Steel
(2) Protective boot
(3) USB cable
(4) Bungee adapter
2. CUSTOMIZE
1. Connect your device.
www.movescount.com/dm5
2. Download and install DM5 software.
depth, m
0
synchronizing
DO NOT DISCONNECT
19:36 Air
dive time
0'
NOTE:
Do not disconnect cable while syncing.
3. After customizing your device, disconnect
the USB cable.
NOTE:
Buttons are locked while cable is connected.
3. SET DIVE SETTINGS 4. SET DIVE GAS(ES)
1. Keep middle button pressed to access menu. 1. Keep middle button pressed to access menu. 1.
depth, m
0
2s
19:36 Air
dive time
0'
2. Scroll with upper or lower button to Dive 2. Scroll with upper or lower button to
settings and select with middle button. Gas and select with middle button.
General Dive settings
3. When settings are ready, keep middle button
3. Select the gas according to your dive plan.
pressed to go back and exit.
Select Edit if your mix is not in the list.
depth, m
0
2s
19:36 Air
dive time
0'
5. PAIR SUUNTO TANK POD
1. Install Tank POD and open tank valve.
depth, m
0
2s
19:36 Air
dive time
0'
2. Wait for green LED on Tank POD to flash.
3. If your EON Steel has a blank screen, press
any button to activate it.
4. Hold your device close to the Tank POD
as shown.
General Gases
19:36
5. Select the gas for the Tank POD.
NOTE:
Air
In CCR mode, you can
set both OC and CC
gases.
depth, m
0
Air
dive time
0'
WARNING:
The battery level indication
shown when pairing the Tank
Air
POD is an approximation only.
The POD battery may deplete
faster than the indication
suggests.