Installing The Display Assembly (Laptop) - Dell Latitude 5330 2in1 Service Manual

Steps
1. Peel the mylar and unroute the WLAN antenna cables from the routing guide.
2. Peel the adhesive tape covering the IR camera cable connector.
3. Remove the (M2x4) screw that secures the display cable bracket to the system board.
4. Lift the display cable bracket off the system board.
5. Open the latch and disconnect the IR camera cable from its connector on the system board.
6. Using the pull tab, disconnect the display cable from the connector on the system board.
7. Remove the two (M2.5x4) screws that secure the left-display hinge to the system board.
8. Remove the two (M2.5x4) screws that secure the right-display hinge to the system board.
9. Open the palm-rest assembly at an angle.
10. Gently slide the palm-rest assembly off the display assembly carefully.

Installing the display assembly (laptop)

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
72 Removing and installing components