Folding The Handle; Storing The Machine In The Vertical-Stow Position - Toro 21611T Operator's Manual

Folding the Handle

WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the battery from the machine.
2. Disengage the handle locks until you can move
the upper handle freely
Note:
Hold the handle while disengaging the
handle locks to avoid pinching your hands.
Figure 13
3. Fold the handle forward to the fully forward
position as shown in
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
4. To unfold the handle, refer to
Handle (page 8).
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
(Figure 13).
Figure 14.
1 Unfolding the
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the battery pack from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to
Height (page
3. Disengage the handle locks
4. Fold the handle fully forward.
Important:
of the handle locks as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
g410315
17
Adjusting the Cutting
12).
(Figure
Route the cables to the outside
(Figure
Figure 14
13).
14).
g410317