Toro 21611T Operator's Manual page 11

Important:
Hold the handle while engaging the handle locks to avoid pinching your hands.
1. Remove the handle knobs (A of
2. Using the holes at the ends of the handle, attach the handle to the machine (B of
3. Move the handle rearward to the operating position (C of
4. Ensure that the cables are routed in front of the handle (D of
5. Engage the handle locks until the pin clicks in place to lock the handle into the operating position (E of
Figure 3).
Note:
You may adjust the height of the handle by changing the hole for the handle lock.
6. Secure the knobs to the handle bolts to secure the handle (F of
Figure 3).
Figure 3
9
Figure 3).
Figure 3).
Figure 3).
g415126
Figure 3).