Folding The Handle; Maintenance - Toro Recyler 20373 Operator's Manual

1. Washout port
6. Turn the water on.
7. Start the engine and run it until there are no more
clippings that come out from under the machine.
8. Shut off the engine.
9. Shut off the water and disconnect the garden hose
from the machine.
10. Start the engine and run it for a few minutes to dry the
underside of the machine to prevent it from rusting.
11. Allow the engine to cool before storing the machine
in an enclosed area.

Folding the Handle

WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets

Maintenance

Replacement parts are available from an Authorized Service
Dealer or at www.torodealer.com (US customers only).
Note: Determine the left and right sides of the machine from the normal operating position.
Figure 29
(Figure 30).
Important: Route the cables to the outside of the
handle knobs as you fold the handle.
g195429
1. Handle knob (2)
2. Fold the handle by rotating it forward
1. Operating position
3. Loosely install the handle knobs and carriage bolts on
the handle brackets.
4. To unfold the handle, refer to
Height (page
Engine parts are available only from an Authorized Service
Dealer.
16
Figure 30
2. Carriage bolt (2)
(Figure
Figure 31
2. Folded position
Adjusting the Handle
10).
g032869
31).
g195431