Chapter 10
10.4.9 Feed Roller
10.4.9.1 Removing the Feed Roller
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Remove the pickup/feed roller unit.
2) Remove the screw [1], and then remove the roller bracket [2].
3) Remove the feed roller [3].
[2]
F-10-30
10.4.10 Original Sensor
10.4.10.1 Removing the Document Set Sensor
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Remove the rear cover.
2) Remove the connector [1], release the hook, and then remove the
document set sensor [2].
[2]
[1]
F-10-31
10.4.11 Separation Rear Sensor
10.4.11.1 Removing the Separation Rear Sensor
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Detach the rear cover.
2) Release the hook, remove the separation rear sensor [1], and then
disconnect the connector [2].
[1]
[2]
F-10-32
10-12
0013-1445
[1]
[3]
0013-1254
0013-1450
10.4.12 Registration Sensor
10.4.12.1 Removing the Registration Sensor
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Remove the front cover and open/close cover.
2) Open the ADF, remove the three screws [1], and then detach the ADF left
lower cover [2].
[1]
F-10-33
3) Release the two claws [1], and then remove the grounding plate [2].
[2]
[1]
F-10-34
4) Disconnect the connector [1], release the hook, and then remove the
registration sensor [2].
[1]
[2]
F-10-35
10.4.13 Document Edge Sensor
10.4.13.1 Removing the document Edge Sensor
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
1) Detach the front cover and open/close cover.
2) Open the ADF, remove the three screws [1], and then detach the ADF left
lower cover [2].
[2]
0013-1449
0013-1446