Location & Assembly - Scotsman CME1356 User Manual

CME1356 and CME1656
Location & Assembly
The air cooled models take room temperature air
in from the left side and the front and discharge
warm air out the back.
A 6 inch minimum clearance on the back, and
both sides is required for the proper operation and
service of the air cooled model.
Unpacking and Assembly:
Begin with unpacking the ice storage bin. Remove
the carton, and using part of the carton as a
cushion, tip the bin on its back to remove the skid
and attach the legs or casters.
Note: Stacked applications may not use casters.
Return the bin to an upright position. Check the
bin top gasket for gaps and tears, fill any in with
food grade sealant prior to placing the ice machine
on the bin.
Level the top edge of the bin front to back and
left to right.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. After
removal of the shipping straps, lift the ice machine
off the skid directly onto the bin.
Note: The machine is heavy! Use a mechanical
hoist if necessary.
Secure the ice machine to the bin with the
hardware provided (two metal straps and 4 bolts).
Locate the Bin Thermostat Bracket and hardware.
Retain for later use.
Aiir cooled: Remove baffle from its shipping
position and secure to the back of the cabinet.
Follow the directions on the baffle for proper
installation.
Cabinet Panel Removal:
Note: The top panel holds the upper edges of the
side panels in place.
1. Remove the front panel by removing the two
screws connecting the front panel to the machine.
2. Lift up at the front edge and push the top panel
back until it releases from the tabs connecting it to
the back panel.
3. Remove the screws at the front edge of the left
side panel, and pull forward until it releases from
the tabs connecting it to the back panel.
August 2003
Page 6