Table of Contents
Advertisement
INSTALLATION
WARNING:
ELECTRIC
SHOCK HAZARD
All servicing requiring
access to non-insulated
electrical components must
be performed by a factory
authorized technician.
DO NOT open any access
panel which requires the use
of tools. Failure to follow this
warning can result in severe
electrical shock.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
ELECTRIC
SHOCK HAZARD
Cord -connected units are
equipped with a three-prong
plug for your protection
against electric shock. Never
cut the large round prong
from the plug, or twist a blade
to fit an existing receptacle.
IMPORTANT:
Contact a licensed electrician
to install the correct circuit
and receptacle (cord-
connected units) or to install
and connect electric power
(field-wired units).
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
ELECTRICAL INSTALLATION
1. Refer to the nameplate. Verify the electrical service power.
Voltage and phase must match the nameplate specifications.
Wiring the unit to the wrong voltage can severely damage the unit,
or cause a significant decrease in performance.
2. Available electrical amperage must meet or exceed the
specifications listed on the specifications sheet provided with the
unit.
a. Units are equipped with a three-prong (grounding) plug for your
protection against electrical shocks. This must be plugged into
a properly grounded matching receptacle.
b. All these units are equipped with a NEMA 5-15P plug and re
quire a matching NEMA 5-15R receptacle.
GROUND
PIN
NEMA 5-15P
6
NEMA 5-15R
PLUG
RECEPTACLE
Advertisement
Table of Contents
