Table of Contents
Advertisement
OPERATION
CAUTION:
ELECTRIC SHOCK
HAZARD
DO NOT splash or pour water
onto control panel or wiring.
RCP units are designed to
hold REFRIGERATED
PRE-CHILLED product at
serving temperature.
RCP units should not be used
to chill product, nor to hold
product for long term storage.
OPERATION NOTES
1. Never place food directly in cold tank. Always use insets or food
pans.
2. Use only pre-chilled products. Stir product occasionally to maintain
an even temperature.
3. Use perforated bottom strainer plates when operating units with
ice. Perforated bottom strainer plates are optional and must be
ordered separately.
4. Reminder: only models RCP-7200SL thru RCP-7400SL are NSF-7
listed for use with potentially hazardous foods. RCP-200SL thru
RCP-400SL are NSF-2 listed.
5. Periodically clean condensing coils to remove accumulated dust
and debris. Failure to clean coils will decrease performance and
may void the warranty.
See CONDENSER CLEANING, page 8.
DAILY START-UP
1. Turn POWER SWITCH (located on condensing unit) ON. Allow
unit to run for approximately 30 minutes to reach operating
temperature.
2. Add necessary adapter bars or adapter plates. Adapter bars
provided with the unit are designed to hold 12" x 20" food pans up
to 6" deep.
3. Install appropriate food pans or insets. Place pre-chilled product in
food pans.
DAILY SHUT-DOWN
1. Turn POWER SWITCH OFF. Remove product, food pans and
adapters.
2. Allow unit to defrost before cleaning.
See CLEANING INSTRUCTIONS, page 7.
8
Advertisement
Table of Contents
