Smeg SOPA6301TN Manual page 26

(factory set to 2 hours).
3. Turn the temperature knob to set the
duration of the Pyrolytic cycle from a
minimum of 2 hours to maximum of 3 hours.
Recommended pyrolytic cycle duration:
• Little dirt: L01 - 2:00
• Moderately dirty: L02 - 2:30
• Very dirty: L03 - 3:00
4. Press the temperature knob to confirm the
data entered.
Wait 3 seconds to start the function.
5. Two minutes after the Pyrolytic cycle starts,
the indicator light comes on to indicate
that the door is locked by a device that
prevents the door from being opened.
It is not possible to select any function
once the door lock device has been
activated.
At the end of the Pyrolytic cycle the flashing
wording
buzzer will sound that can be deactivated by
opening the door and/or pressing/turning any
of the two knobs.
The door is locked until the temperature
inside the oven cavity returns to a safe
level.
28 - CLEANING AND MAINTENANCE
is displayed and a
During the Pyrolytic cycle the fans
produce a more intense level of noise
due to a greater rotation speed. This is
an absolutely normal operation,
intended to provide more effective heat
dispersal. At the end of the pyrolytic
cycle, the fans will continue to operate
for long enough to avoid overheating
the walls of adjacent units and the front
of the oven.
During the first Pyrolytic cycle,
unpleasant odours may occur due to
the normal evaporation of oily
manufacturing substances. This is an
absolutely normal phenomenon which
disappears after the first pyrolytic cycle.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
Setting of a programmed Pyrolytic cycle
It is possible to program the Pyrolytic cycle start
time like all other cooking functions.
1. After selecting the Pyrolysis function, turn the
temperature knob (the indicator light
lights up) to set the time at which you want
the Pyrolysis function to end.
2. Wait 3 seconds to confirm the data entered.
The appliance waits until the set start time to start
the Pyrolytic function.
It is not possible to select any function
once the door lock device has been
activated. It is always possible to switch
the appliance off, by turning the function
knob to the 0 position.
End of pyrolytic function
1. Turn the function knob to position 0 to exit
the function.
2. Open the door and collect the residue
deposited inside the oven cavity with a
damp microfibre cloth.
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.
91477A235/B