Table of Contents
Advertisement
AXIS M5065 PTZ Network Camera
About wireless I/O (Z-Wave Plus
•
COMMAND_CLASS_VERSION
Considerations
Before using wireless I/O with Z-Wave Plus, consider the following:
•
You need to be an administrator to do the Z-Wave configurations.
•
When performing Z-Wave related actions on the product's web page, such as adding, removing and replacing Z-Wave
devices or resetting the Z-Wave network, we recommend that you do not reload the page or move away from it when the
action process is ongoing. If done, the action's actual and displayed statuses may differ. To recover, you may need to wait
up to several minutes and then reload the page again.
•
Replication, i.e. copying network information to another control device, is executed as part of the inclusion process.
•
This product ignores all commands in the Basic Command Class.
•
If the network primary controller is missing or otherwise inoperable, you need to reset to factory default settings from the
product's web page. To do this, go to Setup > System Options > Maintenance, and click Default.
How to add a Z-Wave device
Though not limited by the Z-Wave Plus protocol, your product's event system allows you to add a maximum of six Z-Wave devices
at any given time. If the maximum number is reached, you need to remove a Z-Wave device before you can add a new one.
See How to remove a Z-Wave device on page 43.
1. Go to Setup > Wireless I/O.
2. Select Enable Z-Wave and click Save. You may need to wait for a few minutes for Z-Wave to become active.
3. Click Add. The product starts looking for Z-Wave devices in the Z-Wave network.
4. Set the Z-Wave device to be added into learning (inclusion/exclusion) mode as described in its User Manual.
5. If requested, enter the PIN delivered with the Z-Wave device, and click Enter.
6. Wait until the adding process is finalized as indicated by Status: Done on the web page. The device's status information
window opens.
7. Click Refresh to update the Z-Wave device info, e.g. battery status, and add a name for the device. Click Save.
The added Z-Wave device with some status information is now visible on the Z-Wave Device List.
Note
If the Z-Wave device is not found, the adding process is terminated automatically.
To check the more detailed status information of the added Z-Wave device, select it from the Z-Wave Device List, and click Modify.
Note
Status information for an added Z-Wave device varies depending on the device type. Fore more information, see the
online help
You can set the product to trigger action rules with specified Z-Wave trigger conditions. The available Z-Wave triggers and actions
vary depending on the added Z-Wave device type. For more information, see How to set up action rules on page 34.
.
®
)
42
Advertisement
Table of Contents
