Table of Contents
Advertisement
No.
Mode
15
Deflector Angle
16
Auto Class
17
Auto Separate
18
Ink/Master Left
19
Type of Paper
Description
You can change the angle of the wing guide depending on the pa-
per type you use.
Note
❒ Default: Auto
❒ Available settings:
• Up (Select this setting when standard thickness or thin pa-
per misfeeds at the paper exit section occur frequently.)
• Down (Select this setting when A4 – B5, 8
paper is not delivered properly to the paper delivery tray.)
When you do not use the Separation mode, you can select the ma-
chine's condition after each printing set is fed out to the paper de-
livery tray.
Note
❒ Default: Stop
❒ Available settings:
• Start printing automatically (After the last page of each
printing set is fed out to the paper delivery tray, the ma-
chine stops for a few seconds. Then, the next cycle begins.)
• Stop (After the last page of each printing set is fed out to
the paper delivery tray, the machine stops. If you press the
{ { { { Print} } } } key, the next cycle begins.)
Specifies whether Job Separation mode is automatically carried
out when you make prints in All Class, Auto Class, Manual Class,
or Class mode.
Note
❒ Default: ON
Specifies whether you can check the amount of ink and master.
Note
❒ Default: OFF
❒ Available settings:
• OFF (You cannot check the remaining amount of ink or
master.)
• ON (When the remaining amount of ink or master is less
than half, the panel display indicates these amounts when
you turn on the main switch.)
• Check remaining volume (You can see the remaining
amounts of ink and master regardless of these amounts.)
When one kind of paper misfeed occur frequently, you can regis-
ter its paper type in "User1" or "User2".
Reference
For registering a special paper type, see p.163 "4-19 Type of
Paper".
User Tools Menu
" × 11" thick
1
/
2
151
4
Advertisement
Table of Contents
