Using The Audio Output Jacks - Sanyo DS31810 Owner's Manual

CONNECTING A SATELLITE SYSTEM AND CABLE TO THE TV
1. Connect signal (cable or antenna) to the TV 75Ω (ohm) terminal
2. Connect Satellite S-Video Out to TV S-Video In-1 jack.
Using the S-Video In-1 jack overrides the Video1 Input jack.
3. Connect the Satellite Audio Out (R/L) jacks to TV Audio Input (R/L) Jacks.
Press POWER key to turn on the TV. Turn on external equipment also.
Cable or Antenna
system
(See page 4.)

USING THE AUDIO OUTPUT JACKS

CONNECTING A STEREO AMPLIFIER TO AUDIO OUT JACKS
1. Connect the TV Audio Output (R/L)
2. Press POWER to turn on the TV. Turn on external equipment also.
Note: Cables are not supplied with TV.
UHF/VHF/CATV
S-VIDEO IN - 1
75Ω
(MON0)
AUDIO
R L
AUDIO
VIDEO
INPUT
1
AUDIO
VIDEO
INPUT
2
R AUDIO L
(MON0)
Back of TV
CATV IN
CH3
CH4
OUT TO TV
Back of
Satellite
Receiver
UHF/VHF/CATV
S-VIDEO IN - 1
75Ω
R AUDIO
AUDIO
VIDEO
INPUT
1
AUDIO
VIDEO
INPUT
2
R AUDIO
Back of TV
to the Stereo Amplifier In (R/L)
S-VIDEO IN - 2
VIDEO
L
R
VIDEO AUDIO
OUTPUT
.
VIDEO R- AUDIO -L
S-VIDEO
VIDEO R- AUDIO -L
S-VIDEO IN - 2
(MON0)
L VIDEO
L
R
L
VIDEO AUDIO
OUTPUT
(MON0)
.
Stereo Amplifier
QuickTips
Always match cables
according to the
colors;
RED
audio,
WHITE
audio and
video.
Make sure all cable
connectors are fully
IN FROM
seated on the jacks.
SAT.
Make sure you select
TV channel to match
your VCR output (Ch.
3 or 4). See chart on
page 15.
To view two TV
programs or watch a
TV program and pre-
recorded tape at the
same time, follow
steps on page 14.
If you are connecting
your TV to a satellite
dish, you must
connect a cable
system or antenna
with the satellite to
use the PIP feature.
Position your TV at
least 2 feet from
stereo speakers. The
magnets in the speak-
ers may affect the
picture quality.
Do not connect
external speakers
directly to the TV.
Need help?
Visit our website at
www.sanyoctv.com
or
Call 1-800-877-5032
for right
for left
for
YELLOW
13