Precor Experience 700 Line Elliptical Fitness Crosstrainer Series Assembly Manual page 9

Hide thumbs Also See for Experience 700 Line Elliptical Fitness Crosstrainer Series:

There are latches on the plastic covers that must be engaged to ensure a good

fit. Review the follow procedure before starting the cover assembly.

To attach the side covers:

Position one of the side covers against the console frame with its ramp latch

setting on top of the ramp and its wing edge fitted into the arm as shown

below.

Important Flex the plastic to fit it against the frame. DO NOT pinch or crush

the cable during assembly.

Position the second side cover against the console frame.

Identify where the covers join on the bottom and press upward to snap the

internal latch together.

Figure 11

Figure 12

4. Press the top of the covers together to engage the top internal latch.

Snap a pivot bracket onto the boss of each side cover and then attach each

bracket using two screws

Note The bracket should fit tightly against the assembly.

Figure 13

Figure 14

Table of Contents