Precor Experience 700 Line Elliptical Fitness Crosstrainer Series Assembly Manual page 7

To attach the moving arms:
1. Slide the moving arm into the arm frame and attach the arm using a dog
head bolt and fully tighten using a 3/16 hex wrench.
Note The arms are labeled Left and Right.
2. Fit an inner link cover onto the link arm.
Figure 5
Figure 6
3. Screw the link arm into the base of the moving arm.
4. Screw the link arm into the base of the moving arm (the bolt shops
installed in the link arm assembly).
5. Fit the outer Link cover onto the link arm and attach it using a Phillips
head screw .
Figure 7
6. Perform these steps to attach the other arm.
Note If you are going to mount a PVS or networked console, route those
cable through the frame at this time.
7