Touchpad Assembly - HP ProBook 470 G5 Maintenance And Service Manual

TouchPad assembly

Description
TouchPad assembly
TouchPad assembly cable (included in Cable Kit)
Before removing the TouchPad assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service doors
b. Hard drive
c. Keyboard
d. Top cover
Remove the TouchPad assembly:
1. Position the top cover upside-down.
2. Remove the 6 broad head Phillips M2.0×2.0 screws (1) that secure the TouchPad to the top cover.
3. Lift the TouchPad off the top cover (2).
Reverse this procedure to install the TouchPad assembly.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Service doors on page
(Hard drive on page 37)
(Keyboard on page 40)
(Top cover on page 44)
(Battery Safe mode on page
31).
Spare part number
L00846-001
L00848-001
30).