Table of Contents
Advertisement
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
Maintenance
Cleaning
Clean the cutting deck, under the belt covers and under the cutting
deck.
Clean around the silencer
Clean the engine cooling air intake and transmission air intake
Check/adjust front and rear wheel rotation speed
Checking the engine's cooling air intake
Check the engine's oil level
Check the fuel pump air filter
Check the steering wires
Check the battery
Check the safety system
Check nuts and screws
Check for fuel and oil leakage.
Check the cutters in the cutting deck
Checking the tyre pressure
Check/adjust parking brake
Check the V-belts
Check the oil level in the transmission, top up if necessary.
Checking and adjusting of throttle wire
Check the fuel hose. Replace if necessary .
Change the oil in the gearbox
3, 4)
Change the engine oil
Replace the air filter's prefilter and paper filter
Replace the fuel filter.
Change the oil filter
Change filter in the transmission
Replace the spark plug.
Lubricate the belt adjuster
1)
Lubricate joints and shafts
1)
If the machine is used daily it should be lubricated twice a week.
3)
dusty conditions.
First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every
4)
50 hours.
Replace the oil filter every 200 hours.
7)
service workshop.
After the first 50 h then every 200 h, or at least once a year.
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
!
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
The cutting unit is disengaged.
The ignition cables are removed from the plugs.
WARNING! When the machine is in operation the hoses are under high pressure. Do not try to connect or
!
disconnect the hoses when the hydraulic system is operational. This can result in serious personal injuries.
Maintenance
6,8)
6)
7)
2, 5)
7)
1)
5)
Replace the paper filter annually or every 200 hours.
Daily
At least
maintenance
once a year
before starting
X
O
2, 6)
X
X
X
X
X
X
O
O
X
O
2)
Maintenance and replacement are required more often in
8)
Only AWD-machines
Maintenance interval in
hours
25
50
100
X
O
O
O
O
X
X
X
X
X
X
O
O
O
O
O
X
X
O
O
O
X
X
X
X
X
X
X
O
X
X
X
X
X
X
X
6)
Conducted by authorised
English
200
O
O
X
X
O
X
O
X
X
X
X
O
X
X
X
– 17
Advertisement
Table of Contents
