Ariens Max Zoom 48 CARB Owner's/Operator's Manual page 17

IMPORTANT: Excessively oxygenated or
reformulated fuels (fuels blended with
alcohols or ethers) can damage the fuel
system or cause performance problems. If
any undesirable operating problems occur,
use a gasoline with a lower percentage of
alcohol or ether.
Fuel Stabilizer
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
PRE-START
CAUTION: Make sure all hardware
is tight, all safety devices are in
place and all adjustments are made
correctly.
1. Check Safety Interlock System
If this system does not function as described
do not operate until repairs are made.
2. Check Air Cleaner
Check air filter for dirt. Clean as required.
Follow Engine Manual Maintenance
Schedule.
3. Check Engine Fuel and Crankcase
Oil
Check and add fuel if required. Check that
engine crankcase oil is full. Follow Engine
Manual Maintenance Schedule.
4. Check Tire Pressure
See Specifications on page 33 for correct tire
pressure.
5. Check Hydraulic Fluid Level
See Check Hydraulic Fluid Level on page 21.
6. Adjust Seat
Be sure all controls can be reached safely
from operator's position.
7. Set Cutting Height
Make sure the deck is set to the correct
cutting height.
STOPPING IN AN EMERGENCY
WARNING: Operating unit on
slopes may lead to loss of steering
control. When operating on slopes
be prepared to react to an
emergency situation.
1. Return steering levers to neutral position.
2. Immediately set parking brake.
3. Turn off PTO and engine.
STARTING AND SHUT OFF
CAUTION: Read entire
Owner/Operator Manual, Clutch
Manual, and Engine Manual first.
DO NOT attempt to start engine at
this time.
To start the engine:
1. Make sure the steering levers are in
neutral.
2. Put the PTO switch in the "Off" position.
3. Engage parking brake.
4. If the engine is cold, move the choke
control to the "On" position. If the engine
is warm or hot, do not use choke.
5. Move the throttle to 3/4 "Fast" position.
See Engine Manual for detailed
instructions.
6. Put the ignition key in the switch and
turn it to the "Start" position.
7. As soon as the engine starts, release the
key.
8. Move the choke control to the "Off"
position from the "Choke" position. Wait
until the engine is running smoothly
before operation.
To stop the engine:
1. Bring the steering levers to neutral.
Disengage the PTO and engage the
parking brake.
2. Move the throttle lever to the "Slow"
position.
3. Turn the ignition key to the "Off" position.
TO MOW WITH UNIT
Operate the unit only when seated in the
operator's position.
1. Start the engine. Let the engine warm
until it is running smoothly.
2. Release parking brake.
EN - 17