Hunter Georgetown Installation Manual page 6

Installation
– Canopy Mount and Terminal Wiring
1b
Single Switch Wiring Single Switch Wiring
Green, Green Yellow Stripe, or Bare (grounding) Green, Green Yellow Stripe, or Bare (grounding)
White (grounded) White (grounded)
Black (ungrounded) Black (ungrounded)
1b
Dual Switch Wiring Dual Switch Wiring
Green, Green Yellow Stripe, or Bare (grounding) Green, Green Yellow Stripe, or Bare (grounding)
White (grounded) White (grounded)
Light Light
Black Black
(ungrounded) (ungrounded)
(ungrounded) (ungrounded)
6
(continued)
Connect wiring from ceiling to terminal block (on side of canopy
mount) and tighten using flathead screwdriver (included).
WARNING
The ceiling fan must be grounded. If the ground wire for the
installation site is not present, immediately STOP installation
and consult a qualified electrician.
WARNING
All wiring must be in accordance with national and local
electrical codes ANSI/NFPA70. If you are unfamiliar with
wiring or in doubt, consult a qualified electrician.
Connect wiring from ceiling to terminal block (on side of canopy
mount) and tighten using flathead screwdriver (included).