Assembling - Echo GT-2150 Operator's Manual

Loop handle
Bolt
Bearing housing
Screw
Shield
Bearing housing
Drive shaft
Cutter head
Locking tool
A

ASSEMBLING

Wing nut
150 - 200 mm
Grip
CUT-OFF KNIFE
LOOP-HANDLE
•
Remove wing nut and bolt from loop handle.
•
Push handle over drive shaft housing
approximately 150 - 200 mm from grip.
•
Adjust location of handle to a convenient
operating position.
Secure in position with bolt and wing nut.
SHIELD
•
Install shield to bearing housing as shown.
•
Fit and tighten screw to secure shield on
bearing housing.
CAUTION
Do not operate trimmer without shield in
correct position.
NYLON LINE CUTTER HEAD
CAUTION
Stop engine before handling cutter head.
•
Rotate drive shaft until holes in fixing plate
and in bearing housing are aligned.
•
Insert locking tool through these holes.
•
Install cutter head to drive shaft rotating
clockwise viewed from site of arrow (A).
•
Remove locking tool.
CUT-OFF KNIFE
•
Fit the cut-off knife securely in position as
illustrated.
NOTE
Knife will normally cut the nylon line to the
required length.
13 GT-2150/2150S