Air cleaner cover with air filter
Fuel filter
Low speed mixture
adjusting screw (L)
High speed mixture
adjusting screw (H)
GT-2150/2150S
MAINTENANCE AND CARE
Carburettor
Idle speed adjuster (T)
If you have any questions or troubles, please contact
ECHO dealer.
CLEANING AIR FILTER
•
Close choke and remove air cleaner cover.
•
Remove air filter (air filter is located inside air
cleaner cover).
•
Brush dirt from filter or clean with compressed
air.
•
Reinstall filter and cover.
NOTE
If filter is excessive dirty or no longer fits
properly, replace it.
REPLACING FUEL FILTER
•
Use a piece of steel wire or the like to pick up
fuel filter through fuel tank opening.
•
Pull old filter from fuel line.
•
Install new fuel filter.
CARBURETTOR ADJUSTMENT
Every unit is test run at the factory and the carburettor
is fine tuned for maximum performance.
Any change from this setting should be performed
only with the aid of an accurate tachometer (see
Specification for r/min setting).
If carburettor adjustment is performed without a
tachometer, only the Basic Setting adjustment is
recommended.
Before adjusting carburettor, clean or replace air filter,
start engine and run several minutes to bring it to
operating temperature.
20