Toshiba BA420T Series Owner's Manual page 17

2. PRINTER SETUP
2.3 Loading the Media
(Cont.)
NOTES:
1. Be sure to set the Black
Mark Sensor to detect the
centre of the black mark,
otherwise a paper jam or no
paper error may occur.
2. After adjusting the Black
Mark Sensor position, align
the Upper Feed Gap
Sensor with the Lower Feed
Gap Sensor. This is
because a paper end is
detected by the Feed Gap
Sensor.
Setting the Black Mark Sensor position
When using media with black marks, the Black Mark Sensor is used to
detect a print start position.
(1) Push the Upper Sensor Lever inside and open the Upper Sensor
Ass'y.
(2) Check the reverse side of the media for the black mark position.
(3) Slide the Lower Sensor Tab to move the Black Mark Sensor so that
it is in line with the center of the black mark on the media.
( indicates the position of the Black Mark Sensor).
Black Mark
Sensor
(4) Lower the Upper Sensor Ass'y until the Upper Sensor Lever clicks
in position.
E2- 7
ENGLISH VERSION
2.3 Loading the Media
Lower Sensor
Tab