Toshiba BA420T Series Owner's Manual page 43

6. APPENDIX 1 INTERFACE
ENGLISH VERSION
6. APPENDIX 1 INTERFACE
(8) Ambient Temperature
Wireless performance is affected by ambient temperatures, therefore writing data on an RFID tag may
fail if ambient temperature changed from at the time of temperature of RFID setting.
(9) Strip Issue
Stripping performance in strip issue mode depends on the type of adhesive, tag, and backing paper. For
some RFID media used, a strip issue may not be performed properly.
(10) Caution for Minimum Label Pitch Length
When using media, with a short label pitch length, data may be written on an RFID tag adjacent to the
target RFID tag and it may not be able to write on target RFID tag.
As the location, where data is to be written, differs among RFID tag types, a check must be performed to
make sure that the data is written on the target RFID tags. The BCP RFID Analyze Tool can be used for
this purpose. For details, please contact the nearest Toshiba Tec support representative.
(11) Defective RFID Media
RFID media may include defective RFID tags at the time of shipment from the maker. The defect rate
differs depending on tag types, method of converting to media, etc.
The RFID media manufacturer should provide a way to identify defective tags by printing a mark on
them or any other methods.
Or, defective tags should be rejected in the production process.
The end users must be notified on how to identify a defective tag from a good one.
(12) Automatic Calibration(Key Operation:<2>SET PARAMETERS-CALIBRATE)
Do not use Automatic Calibration feature for using RFID media. (Please set "CALIBRATE" to OFF)
Regarding to setting this feature, please refer to BA400 Series Key Operation Specification.
E6-8