Toshiba BA420T Series Owner's Manual page 16

2. PRINTER SETUP
2.3 Loading the Media
(Cont.)
NOTE:
Be sure to align the Upper
Feed Gap Sensor with the
Lower Feed Gap Sensor.
Failure to do this cause a
paper jam error.
11. After loading the media, it may be necessary to set the position of
the Media Sensor used to detect the print start position for label or
tag printing.
Setting the Feed Gap Sensor position
When using a label stock without black marks, the Feed Gap Sensor is
used to detect a print start position.
(1) Push the Upper Sensor Lever inside and open the Upper Sensor
Ass'y.
(2) Slide the Lower Sensor Tab with your finger to move the Feed Gap
Sensor so that the Feed Gap Sensor is positioned at the center of the
labels. ( indicates the position of the Feed Gap Sensor).
It may be easier to move the Lower Sensor Tab if you use a pen
inserting its tip into the pinhole of the tab.
Feed Gap Sensor
(3) Lower the Upper Sensor Ass'y until the Upper Sensor Lever clicks
into position.
(4) Slide the Upper Sensor Tab to move the Feed Gap Sensor so that it
aligns with the lower Feed Gap Sensor.
Feed Gap Sensor
E2- 6
ENGLISH VERSION
2.3 Loading the Media
Lower Sensor Tab
Upper Sensor Tab