Fluke 726/FPC User Manual page 13

726
Users Manual
To avoid possible electric shock or personal injury:
• Use the Calibrator only as described in the Users Manual or the protection provided by the Calibrator
may be impaired.
• Do not apply more than the rated voltage, as marked on the Calibrator, between the terminals, or
between any terminal and earth ground (30 V 24 mA max all terminals).
• Before each use, verify the Calibrator's operation by measuring a known voltage.
• Follow all equipment safety procedures.
• Use the proper terminals, mode, and range for the measuring or sourcing application.
• Never touch the probe to a voltage source when the test leads are plugged into the current terminals.
• Do not use the Calibrator if it is damaged. Before using the Calibrator, inspect the case. Look for cracks
or missing plastic. Pay particular attention to the insulation surrounding the connectors.
• Select the proper function and range for the measurement.
• Make sure the battery door is closed and latched before operating the Calibrator.
• Remove test leads from the Calibrator before opening the battery door.
• Inspect the test leads for damaged insulation or exposed metal. Check test lead continuity. Replace
damaged test leads before using the Calibrator.
• When using the probes, keep your fingers away from the probe contacts. Keep fingers behind the finger
guards on the probes.
• Connect the common test lead before connecting the live test lead. When disconnecting the test leads,
disconnect the live test lead first.
• Do not use the Calibrator if it operates abnormally. Protection may be impaired. When in doubt, have the
Calibrator serviced.
• Do not operate the Calibrator around explosive gas, vapor, or dust.
4
information@ITM.com
XW Warning
Fluke-Direct
.ca
1.800.561.8187