Outline Of Operation Control By Microcomputer; Operation Control Function By Remote Control - Mitsubishi Heavy Industries SRK25ZMP-SJ Technical Manual

9. OUTLINE OF OPERATION CONTROL BY MICROCOMPUTER

(1) Operation control function by remote control

Remote control
S Operation section
FAN SPEED button
Each time the button is pressed, the
display is switched over in turn.
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
TEMPERATURE button
These buttons set the room temperature.
(These buttons are used for setting the
current time and timer function as well.)
ON TIMER button
This button selects ON TIMER operation.
SLEEP button
This button selects SLEEP operation.
CLEAN switch
This switch selects the CLEAN mode.
CANCEL button
This button cancels the ON timer, OFF
Name of each part and its function
timer, and SLEEP operation.
Unit display section
• The above illustration shows all controls, but in practice
only the relevant parts are shown.
Remote control signal receiver
Unit ON/OFF button
This button can be used for turning on/off the unit when remote control is not available.
RUN (HOT KEEP) light (green)
Illuminates during operation.
Blinks when airflow stops due to the 'HOT KEEP' and 'CLEAN operation'.
1.5 sec.
ON
HOT KEEP
OFF
0.5 sec.
TIMER light (yellow)
Illuminates during TIMER operation.
24
- -
'13 • SRK-T-152
OPERATION MODE select button
Each time the button pressed, the
display is switched over in turn.
ON/OFF (luminous) button
Press to start operation, press again to
stop.
AIR FLOW (UP/DOWN) button
This button changes the air flow (up/down)
direction.
OFF TIMER button
This button selects OFF TIMER operation.
ACL switch
This switch is for resetting microcomputer
and setting time.
3 sec.
ON
CLEAN operation
OFF
1 sec.