LG LFXS28566 Series Technical Manual page 179

Washer Lock Error
Washer foreign object
Washer Wi-Fi communication error
Washer Wi-Fi module problem
Washer Outlet Error: Draining Problem
Washer Pressure Error
Washer Power Failure
Washer/combo Restricted dry fan
Washer Sensor Error
Washer Sud Error
Washer Tub Clean
Washer Thermistor Error
Washer Unbalance Error
Washer Unbalance Error
The LE error indicates a problem with the Direct Drive
motor control. Note: the appliance has a load detection
LE and correction system. If any overload is detected
check for coins pins, clips, etc caught between wash plate
LE1 the inner basket
The nE error indicates a problem with the connection
nE between the Display PCB and the Wi-Fi module.
The nF error indicates a problem with the Wi-Fi module.
Self Check function Error
nF
The OE error indicates a problem with draining the water.
Note: the appliance has a drain detection and correction
OE system
The PE error indicates a problem with the Pressure switch
(water level sensor). The appliance will stop as it cannot
PE continue in the program.
The PF error is a notification that an external short power
outage has occurred. Restarting the appliance restores it
PF to the stage where it has stopped.
PF also used to indicate a restricted dry fan in a washer dryer combo
The SE error indicates a problem with the BLDC motor
rotation and force detection. The tacho sensor cannot
SE provide a proper signal to the controller.
Sud
The tCL error is a notification that the appliance should run
a maintenance program to clean the tub. Note: This
program runs with a higher water level
tCL
The tE error indicates a problem related to the heating
system. The appliance has stopped to prevent further
tE damages.
The UE error indicates a problem with balancing of the
load. Note: the appliance has an balance detection and
correction system with an automatic untangle process. If
the untangling of the load did not result in an even
UE distributed load
information code for user
uE
Not connected: a faulty harness: a faulty Display PCB: a
faulty Wi-Fi module
Unplug the appliance. Wait for 60 seconds and restart the
appliance if error reappears maybe a faulty Wi-Fi module
a problem with the water level sensing: a problem with
foam in the air chamber hose: a faulty pressure switch: a
faulty Main PCB
No further actions required
for Washer-Dryer Combo
a faulty tacho sensor: a faulty Main PCB
a failing heater protection: a faulty Main PCB
redistribute load