8.
Adjust the back shell J so it is centered between the back canes K.
9.
Tighten the eight screws L securing the angle adjustable brackets
I to the back shell.
J
K
Part No. 1171914
4.8
1.
L
K
2.
3.
19
Adjusting the Back Height
Loosen the compression bar hardware A.
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw B is designed only to hold the
compression bar in place during installation. Adjusting
this screw may prevent the compression bar from
tightening properly onto the back cane.
Adjust the back to the desired height.
Height adjustments must be made equally on both back
canes.
Tighten the compression bar hardware to secure the clamp bodies
C in place.
When re-tightening the compression bar hardware,
alternate back and forth between the screws until the
compression bar is fully secured.
C
B
A
4 FIXED DUAL MOUNT
Invacare® Matrx® MX1