System Board - HP ProDesk 480 G6 MT Maintenance And Service Manual

System board

NOTE: The system board spare park kit includes replacement thermal material.
Follow these steps to remove the system board:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
a. Front bezel (see
b. WLAN module (see
c. Solid-state drive (see
d. Drive cage (see
e. Fan-sink (see
NOTE:
connector board (see
installed on the replacement system board.
3. Disconnect the following cables from the system board:
(1) Fan cable
(2) Power supply P1 cable
(3) Drive data cables (three locations)
(4) Speaker cable
(5) Power supply P3 cable
(6) Power supply P2 cable
(7) Drive power cable
Access panel on page
Front bezel on page
WLAN module on page
Solid-state drive on page
Drive cage on page
Fan-sink on page
When replacing the system board, be sure that the processor (see
Connector board on page
Preparation for disassembly on page
32), and then remove the following components:
35)
41)
42)
36)
46)
51) are removed from the defective system board and
31).
Processor on page 47) and
System board 49