Fan-Sink - HP ProDesk 480 G6 MT Maintenance And Service Manual

Fan-sink

NOTE: The fan-sink spare park kit includes replacement thermal material.
Follow these steps to remove the fan-sink:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the drive cage (see
Remove the fan-sink:
1. Disconnect the fan-sink cable (1) from the system board.
2. Release the power supply P3 cable from the two retention clips (2) built into the fan-sink.
3. Loosen the four slotted Torx-15 captive screws (3) that secure the fan-sink to the computer chassis.
NOTE:
the processor, it may be necessary to move the fan-sink from side to side when removing the it.
4. Remove the fan-sink (4).
Reverse this procedure to install the fan-sink.
46 Chapter 4 Removal and replacement procedures
Access panel on page
Front bezel on page
Drive cage on page
Due to the adhesive nature of the thermal material located between the fan-sink and
Preparation for disassembly on page
32).
35).
36).
31).