Toshiba RAS-M07G3DV-E Service Manual page 67

Heat insulating process
• As shown in the figure, cover the flexible hose and hose band with the attached heat insulator up to the bottom of the indoor unit without gap.
• Cover the drain pipe seamlessly with a heat insulator locally procured so that it overlaps with the attached heat insulator of the drain connecting section.
10-6. Duct design
Arrangement
Referring to the following dimensions, manufacture duct at the local site.
07,10,13 type
<Under air intake>
A
<Back air intake>
A
<Under air intake>
A: Some models have no drain guaid here.
Wrap the attached heat insulator seamlessly
from the surface of the indoor unit.
Heat insulator of the Heat insulator
drain connecting
(Locally procured)
section (Accessory)
Banding band (Locally procured)
* Direct the slits and seams of the heat insulator
upward to avoid water leakage.
22,24 type
– 66 –
16 type
<Under air intake>
A
<Back air intake>
A
<Back air intake>