2.4 Installation
When hanging the unit on a wall, install screws on the wall or pole, pull out the
wall-mount hooks from the back of the unit and use them to hang the unit on the
wall or pole. Then swing the unit slightly to check that it will not fall. Do not pull
the unit mounted on the wall unnecessarily, or it may cause the mounting hooks
to come off.
When mounting on the wall, refer to the following dimensions and use M3
screws or the like. Securely install the unit to prevent it from falling.
Main unit
Pt sensor connector box for SK-L753
A diameter of the screw holes of the box is 7.5 mm. Using a spacer is advised if
needed to fix the box tightly.