Furuno MU-192HD Operator's Manual page 17

2. Attach the flush mounting sponges H19 and V19 in the order shown in the figure below.
Flush Mounting Sponge (V19)
for right and left
3. Attach the flush mounting panel to the display unit from the rear with the washer head screws
(8 places).
4. Connect all cables at the back of the display unit. See section 1.7.
5. Set the display unit assembly prepared at the step 3 to the cutout for the mounting location.
Narrow
Wide
Flush Mounting Sponge (H19)
for top and bottom
Washer
Head
Screw
Fmount panel 19
assembly
8
1. MOUNTING, WIRING