2. Attach the flush mounting sponges H19 and V19 in the order shown in the figure below.
3. Connect all cables at the back of the display unit. See section 1.7.
4. Set the display unit to the cutout.
5. Attach the attachment 19 to the left and right sides of the back of the display unit with the sup-
plied washer head screws.
Flush Mounting Sponge (V19)
for right and left
Flush Mounting Sponge (H19)
for top and bottom
Cutout
Washer hear screws
(Three on each side)
Attachment 19
(One on each side)
4
1. MOUNTING, WIRING