Start-Up; Selecting The Spray Setting (Perfect Spray Spray Attachment) - WAGNER WallPerfect W 687 E I-Spray Manual

W 687 E I-Spray

10. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
1. Attach the carrying strap to the unit. (Fig. 2)
2. Unscrew the container from the spray gun.
3. Aligning suction tube. (Fig. 3)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
For easier coating of ceilings and lying objects, we recommend the 60 cm
i
HVLP handle extension. (Order no. 2307 678)
4. Set the container on a sheet of paper, pour in the prepared coating material and screw
the container tightly onto the spray gun.
5. Connect the front part with the rear part of the gun. (Fig. 5)
6. Mount the air hose (Fig. 4, A + B). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
7. Sling on the carrying strap with the unit.
8. Press the ON/OFF switch at the device.
the enclosed practice poster is ideal for familiarising yourself with
i
operation of the spray gun. After trying out the first spray coatings, it
makes sense to test it further on cardboard or a similar surface in order
to find out the right flow rate of paint and air for the best spray pattern.
Detailed information about these settings can be found in chapter
11- 14.
11. Selecting the Spray Setting
(Perfect Spray spray attachment)
WArninG!
With the union nut (fig. 6, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
fig. 7 A = horizontal flat jet 
fig. 7 B = vertical flat jet
fig. 7 C = circular jet
Danger of injury! never pull the trigger guard while adjusting
the air cap.
for horizontal surfaces
for vertical surfaces

for corners, edges and hard-to-reach surfaces

GB
27