Start-Up; Adjusting The Desired Spray Setting - WAGNER W 150 Translation Of The Original Operating Instructions

W 150

8. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
•
Set the container on a sheet of paper, pour in the prepared coating material and screw
the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun (Fig. 3).
A selection of spray attachments with different
i
container heights are available as accessories.
Always fold out the handle extension before
placing on the ground if you are using a different
spray attachment to the included Standard
small spray attachment to balance the container
height.
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
Always switch the W 150 on first before pulling the trigger. Otherwise, there
i
will be a delay in the turbine starting up and the material may drip unatomised
from the nozzle.
•
Switch the unit on using the ON/OFF switch (Pos. I).
•
Pull the trigger.
•
Adjust the spray setting on the spray gun.

9. Adjusting the desired Spray Setting

Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 5, 1) slightly unscrewed, turn the air cap (2) to the desired spray
setting position (arrow). Then tighten the union nut.
Fig. 4 A = vertical flat jet
Fig. 4 B = horizontal flat jet  for vertical surfaces
Fig. 4 C = circular jet
 for horizontal surfaces
 for corners, edges and hard-to-reach surfaces
GB
21