Table of Contents
Advertisement
BASIC OPERATIONS
Configuring Network Settings
Note:
Before configuring network settings, make sure to connect the Wi-Fi dongle (optional) or ethernet cable to
the panel.
In the Settings menu, select
‡
Select Wi-Fi to connect the panel to the Wi-Fi network and view current connection status. Make sure the
Wi-Fi function is enabled. In the Available network list, select your preferred Wi-Fi network, for example XXXX.
Provide an access password if needed.
IMPORTANT!
To connect to a Wi-Fi network, make sure the Wi-Fi dongle (optional) is properly connected to
the panel. For more information, refer to page
Note:
If your preferred Wi-Fi network is not visible in the list, select
network manually, select
‡
Select Ethernet to configure LAN settings. In the IP settings section select the network type between static
and DHCP. If you set the network type as Static then select
address, gateway, network prefix length, and more.
IMPORTANT!
To connect to a wired network, you need to properly connect an ethernet cable between the
wired network device (such as a router or switch) and the panel.
48
English
to open the Network menu, then complete the following steps:
.
29.
to refresh the list. To enter the Wi-Fi
and enter the connection settings, such as IP
Advertisement
Table of Contents
