Table of Contents
Advertisement
SETUP AND INSTALLATION
Stand Mounting (Optional)
The stand mount kit includes the following items:
Stand pole (x2)
To mount the panel on the stand, complete the following steps:
1.
Install the dual mounting brackets on the rear of the panel. Then secure the brackets with four
screws (A).
Note:
‡
Dual mounting brackets, wall mount, and screws (A) are included in the wall mount kit. Refer to
"Wall Mounting" on page 15.
‡
Portrait mode installation only supports 90 degrees clockwise (power LED facing down).
Pen tray (x1)
Stand base (x1)
Wheel (x4)
Screw
J
Nut
G
(x4)
Washer
Screw
K
(x4)
Washer
A
(x16)
Screw
H
(x4)
G1
(x4)
Split Ring Lock
G2
Washer
(x4)
K1
(x4)
Nut
K2
(x4)
English
19
Advertisement
Table of Contents
