Specifications
Terminal Connections
Note 1. When the ALARM output turns ON, remove the cause of the high current and then shut off the external
power supply for approx. 1 second. After confirming that the cause has been removed, turn ON the pow-
er supply again to reset the output. As shown in the diagram, it is recommended that a relay or switch that
turns ON or OFF only the external power supply be connected right before the B9 (+V). Check that this
relay or switch has a contact capacity higher than the external power supply current consumption
(35 mA + load current min.).
2. This Unit must be mounted to a C200H-BCjj1-V1/V2 Backplane.
Downloaded from
Elcodis.com
electronic components distributor
All manuals and user guides at all-guides.com
24 VDC
+24 VDC
Appendix B
97