Table of Contents
Advertisement
A-9
RECOMMENDED TOOLS:
• 7/16" nut driver or other suitable tool.
• 5/16" nut driver or other suitable tool.
INSTALLATION:
1. Turn off input power to both power sources and
any other equipment connected to the welding sys-
tem at the disconnect switch or fuse box before
working on the equipment.
Follow steps 2 thru 4 for each S350(CE) or
R350 power source:
Follow steps 5 thru 9 for each S500(CE) or
R500 power source:
2. Remove the top right rubber end caps as well as
the right case side of the Power Source by remov-
ing the twelve screws fastening the end caps and
case side to the Power Source using a 5/16" nut
driver or other suitable tool. Keep the twelve screws
removed for re-installation of the case side and rub-
ber end caps. (FIG 1)
3. Set the Control Board dip switch settings per the
specified chart (FIG. 3)
4. Re-install the right case side and end caps of the
Power Source using the twelve screws removed in
Step 2. Skip down to Step 10.
5. Remove the handles from the Power Source by
removing the eight screws fastening the handles to
the Power Source using a 7/16" nut driver or other
suitable tool. Keep the 8 screws removed for re-
installation of the handles. (FIG 2)
INSTALLATION
6. Remove the top four rubber end caps as well as the
case top of the Power Source by removing the four-
teen screws fastening the end caps and case top to
the Power Source using a 5/16" nut driver or other
suitable tool. Keep the twelve screws removed for
re-installation of panel. (FIG 2)
7. Set the Control Board dip switch settings per the
specified chart (FIG. 3)
8. Re-install the case top and end caps of the power
source using the fourteen screws removed in Step 6.
9. Reinstall the handles of the Power Source using the
eight screws removed in Step 5.
10. To complete the installation, connect the
Interconnect Cable Assembly between the two
Power Sources.
®
AutoDrive
19 Tandem
A-9
Advertisement
Table of Contents
