Table of Contents
Advertisement
10
www.aeg.com
3.7 Gas Connection
WARNING!
The following instructions
about installation,
connection and maintenance
must be carried out by
qualified personnel in
compliance with standards
and local regulations in
force.
Use fixed connections or use a flexible
pipe in stainless steel in compliance with
the regulation in force. If you use flexible
metallic pipes, make sure they do not
come in touch with mobile parts or they
are not squeezed.
The connection must be done according
to NEN 1078.
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values. The
adjustable connection is
fixed to the comprehensive
ramp by means of a
threaded nut G 1/2" (NEN
3258). Screw the parts
without force, adjust the
connection in the necessary
direction and tighten
everything.
WARNING!
The gas connection pipe
must not touch the part of
the appliance shown in the
illustration.
3.8 Flexible nonmetal pipes
connection
If you have an easy access to the
connection, you can use a flexible pipe.
The flexible pipe must be tightly attached
by clamps.
In installation always use the pipe holder
and the gasket. The flexible pipe can be
applied when:
• it can not get hotter than room
temperature, higher than 30 °C,
• it is not longer than 1500 mm,
• it has no narrowing anywhere,
• it is not twisted or tighten,
• it does not get in touch with sharp
edges or corners,
• it's conditions can be easily checked.
When checking the flexible pipe make
sure:
• it does not show cracks, cuts, marks
of burnings on the two ends and on its
full length,
• the material is not hardened, but
shows its correct elasticity,
• the fastening clamps are not rusted,
• expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
The gas supply ramp is on the rear side
of the control panel.
3.9 Adjustment to different
types of gas
Let only an authorized
person do the adjustment to
different types of gas.
If the appliance is set for
natural gas you can change
it to liquid gas, with the
correct injectors.
The gas rate is adjusted to
suit.
WARNING!
Before you replace the
injectors, make sure that the
gas knobs are in the Off
position. Disconnect the
appliance from the electrical
supply. Let the appliance
cool down. There is a risk of
injury.
The appliance is set to
default gas. To change the
setting always use the
gasket sealing.
Advertisement
Table of Contents
