Table of Contents
Advertisement
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric
shock and injury, including the following:
1.
This product should be installed by a qualified technician.
2.
This product should only connect to the host equipment and never directly to the network such as Public Switch
Telephone Network (PSTN) or Plain Old Telephone Services (POTS).
3.
Read and understand all instructions.
4.
Follow all warnings and instructions marked on the product.
5.
Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for
cleaning.
6.
Do not use this product near water such as near a bathtub, washbowl, kitchen sink, laundry tub or swimming pool, or in
a wet basement or shower.
7.
Do not place this product on an unstable table, shelf, stand or other unstable surfaces.
8.
Slots and openings in the back or bottom of the telephone base and handset are provided for ventilation. To protect
them from overheating, these openings must not be blocked by placing the product on a soft surface such as a bed,
sofa or rug. This product should never be placed near or over a radiator or heat register. This product should not be
placed in any area where proper ventilation is not provided.
9.
This product should be operated only from the type of power source indicated on the marking label. If you are not sure
of the type of power supply on the premises, consult your dealer or local power company.
10.
Do not allow anything to rest on the power cord. Do not install this product where the cord may be walked on.
11.
Never push objects of any kind into this product through the slots in the telephone base or handset because they may
touch dangerous voltage points or create a short circuit. Never spill liquid of any kind on the product.
12.
To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility. Opening
or removing parts of the telephone base or handset other than specified access doors may expose you to dangerous
voltages or other risks. Incorrect reassembling can cause electric shock when the product is subsequently used.
13.
Do not overload wall outlets and extension cords.
14.
Unplug this product from the wall outlet and refer servicing to an authorized service facility under the following conditions:
•
When the power supply cord or plug is damaged or frayed.
If liquid has spilled onto the product.
•
If the product has exposed to rain or water.
•
If the product does not operate normally by following the operating instructions. Adjust only those controls covered
•
by the operation instructions. Improper adjustment of other controls may result in damage and often requires
extensive work by an authorized technician to restore the product to normal operation.
•
If the product has been dropped and the telephone base and/or handset has been damaged.
•
If the product exhibits a distinct change in performance.
15.
Avoid using a telephone (other than cordless) during an electrical storm. There is a remote risk of electric shock from
lightning.
16.
Do not use the telephone to report a gas leak in the vicinity of the leak. Under certain circumstances, a spark may be
created when the adapter is plugged into the power outlet, or when the handset is replaced in its cradle. This is a
common event associated with the closing of any electrical circuit. The user should not plug the phone into a power
outlet, and should not put a charged handset into the cradle, if the phone is located in an environment containing
concentrations of flammable or flame-supporting gases, unless there is adequate ventilation. A spark in such an
environment could create a fire or explosion. Such environments might include medical use of oxygen without adequate
ventilation; industrial gases (cleaning solvents; gasoline vapor; etc.); a leak of natural gas; etc.
17.
Only put the handset of your telephone next to your ear when it is in normal talk mode.
18.
The power adapter is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed
to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
19.
For pluggable equipment, the socket-outlet (power adaptor) shall be installed near the equipment and shall be easily
accessible
20.
Use only power supplies and rechargeable battery as indicated in this user guide. Do not dispose of batteries in a fire.
They may explode. Check with local codes for possible special disposal instructions.
21.
In wall mounting position, make sure to mount the telephone base on the wall by aligning the eyelets with the mounting
studs of the wall plate. Then slide the telephone base down on the mounting studs until it locks into place. Refer to the
full instructions in Installation in this user guide.
22.
CAUTION: Keep small metallic objects such as pins and staples away from the handset receiver.
Important safety instructions
SAVE THESE INSTRUCTIONS
Advertisement
Table of Contents
