Table of Contents
Advertisement
17.6
Teaching the throttle valve position
Info
If the control unit detects that the throttle valve position at idle speed needs to be retaught, then the mal-
function indicator lamp flashes 2x per second.
17.7
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Allow the vehicle to run at idle speed.
The malfunction indicator lamp stops flashing once teach-
ing is completed.
Info
If the engine becomes too hot, perform a cool-down
ride at medium revs.
Then do not switch off the engine after this, but leave it
running at idle speed until teaching is completed.
H02263-10
–
Sit on the vehicle in the riding position and determine
A
distance
lever.
Gap between the shift lever
and the top of the boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
(
p. 136)
400692-10
TUNING THE ENGINE 17
between the upper edge of your boot and the shift
10 ... 20 mm (0.39 ...
0.79 in)
135
Advertisement
Table of Contents
