7. Align the new internal speaker with the four metal clips
speaker to the right until it snaps into position.
Figure 177. Installing the internal speaker
8. Connect the internal speaker cable to the internal speaker connector on the system board. See
"Locating parts on the system board" on page 82.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 216.
Replacing the front audio and USB assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 150.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 151.
204
ThinkStation E32 Hardware Maintenance Manual
1
on the inner side of chassis, and then slide the