Lenovo 30A0 Hardware Maintenance Manual page 165

5. Press the release tab
Figure 105. Pivoting the drive bay assembly upward
6. Disconnect the card reader cable from the USB connector on the system board. See "Locating parts on
the system board" on page 82.
7. Remove the screw that secures the card reader bracket. Then, remove the card reader bracket from
the chassis.
Figure 106. Removing the screw that secures the card reader
8. Remove the two screws that secure the card reader to its bracket. Then remove the failing card reader
from the bracket.
9. Install a new card reader into the bracket and install the two screws to secure the card reader to the
bracket.
1 as shown and pivot the drive bay assembly upward.
.
Chapter 11 Replacing FRUs (machine types: 30A2 and 30A3)
159