Installing The Solid-State Drive - Lenovo 30A0 Hardware Maintenance Manual

b. Partially tighten screw
10. Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 74.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 147.

Installing the solid-state drive

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
1. Install the solid-state drive into the storage converter. Then, install the four screws to secure the
solid-state drive to the storage converter.
Figure 38. Installing the solid-state drive into the storage converter
3 , then fully tighten screw
Chapter 10
4 , and then fully tighten screw
.
Replacing FRUs (machine types: 30A0 and 30A1)
3 .
107