Toro 79392 Operator's Manual page 6

2
1
G014878
8
Figure 5
1. Locknut (3/8 inch), existing 5. Hole, existing in frame
2. Forward hole, left side
3. Front left caster (castor
fork and wheel not shown
for clarity)
4. Locknut (3/8 inch), loose
parts
5. On the right side of the machine, install the right
weight-mounting bracket as follows:
•
For machines without a foot assist lift pedal, secure
the bracket using 2 bolts (3/8 x 1-1/4 inches), 2
washers and 2 lock nuts (3/8 inch)
Note: A locknut is from loose parts and the other
is used from earlier removal.
1
8
7
6
G014876
Figure 6
1. Front right caster (castor
fork and wheel not shown
for clarity)
2. Forward hole, right side
3. Locknut (3/8 inch), existing 7. Hole, existing in frame
4. Right mounting bracket
3
4
5
7
6. Washer
7. Bolt (3/8 x 1-1/4 inches)
8. Left mounting bracket
(Figure
2
3
4
5
5. Bolt (3/8 x 1-1/4 inches)
6. Washer
8. Locknut (3/8 inch), loose
parts
Note: For machines with a foot assist lift pedal,
the washers are not used.
•
For machines with a foot assist lift pedal, Remove
the forward fasteners in the foot assist lift pedal
bracket and secure the bracket using 2 bolts and 2
lock nuts
Note: One locknut is from loose parts and the
6
other is used from earlier removal.
7
6
G014883
1. Front right caster (castor
fork and wheel not shown
for clarity)
6).
2. Front hole, right side
3. Locknut (3/8 inch), existing 7. Hole, existing in bracket
4. Right mounting bracket
6. Install the weight bracket to the mounting brackets by
aligning the outboard holes in the bracket with the
mounting brackets installed previously
Note: Make sure the bracket is centered on the frame.
7. Secure the weight bracket with 2 bolts (3/8 x 1 inch)
and 2 locknuts (3/8 inch)
6
(Figure 7).
2
1
8
5
Figure 7
5. Bolt (3/8 x 1-1/4 inches)
6. Foot-assist lift pedal
bracket
8. Locknut (3/8 inch), loose
parts
(Figure
3
4
(Figure 8).
8).