Hyundai Kona Hybrid 2023 Owner's Manual page 624

Maintenance
WARNING
After washing the vehicle, dry the brakes
by applying them lightly while
maintaining a slow forward speed.
NOTICE
• Do not use strong soap, chemical
detergents, or hot water, and do not
wash the vehicle in direct sunlight or
when the body of the vehicle is warm.
• To prevent damage to the plastic parts,
do not clean with chemical solvents or
strong detergents.
NOTICE
2C_VehicleWashCaution
• Water washing in the engine
compartment including high pressure
water washing may cause the failure of
electrical circuits located in the engine
compartment.
• Never allow water or other liquids to
come in contact with
electrical/electronic components
inside the vehicle to prevent damage.
9-68
NOTICE
Matte paint finish vehicle (if equipped)
To prevent damage the matte finish:
• Do not go through an automatic car
wash with rotating brushes.
• Avoid using a steam cleaner. High
temperature steam may leave stains
that are difficult to remove.
• Use a soft cloth (e.g. microfiber towel or
sponge) when washing your vehicle
and dry with a microfiber towel. When
you hand wash your vehicle, do not use
a cleaner that finishes with wax. If the
vehicle surface is too dirty (sand, dirt,
dust, contaminant, etc.), clean the
surface with water before washing the
vehicle.
Waxing
A good coat of wax helps protect your
paint from contaminants..
Wax the vehicle when water no longer
beads on the paint.
Always wash and dry the vehicle before
waxing. Use a good quality liquid or paste
wax, and follow the manufacturer's
instructions. Wax all metal trim to protect
it and to maintain its luster.
Removing oil, tar, and similar materials
with a spot remover usually strips the wax
from the finish. Be sure to re-wax these
areas even if the rest of the vehicle does
not yet need waxing.
NOTICE
• Do not wipe dust or dirt off the body
with a dry cloth to prevent scratching
the finish.
• Do not use steel wool, abrasive
cleaners, or strong detergents
containing highly alkaline or caustic
agents on chrome-plated or anodized
aluminum parts to prevent
discoloration or paint deterioration.