Hyundai Kona Hybrid 2023 Owner's Manual page 525

13.Use the wheel lug nut wrench to
tighten the wheel nuts in the order
shown. Double-check each wheel nut
until they are tight. After changing tires,
we recommend that an authorized
HYUNDAI dealer tighten the lug nuts to
their proper torque as soon as possible.
Tighten wheel nuts to 11-13 kgf.m
(79-94 lbf.ft).
2C_SpareTireReplacementPrecedure_7
Check the tire pressure after installing the
compact spare tire. The compact spare
tire should be inflated to 60 psi (420 kPa).
If you have a tire gauge, check the tire
pressure (refer to the"Tires and wheels"
section in chapter 2 for tire pressure
instructions). If the spare tire pressure is
lower or higher than the recommended,
drive slowly to the nearest service station
and adjust it to the recommended
pressure.
Always reinstall the valve cap after
checking or adjusting the tire pressure. If
the cap is not replaced, air may leak from
the tire. If you lose a valve cap, buy
another and install it as soon as possible.
After changing tires, secure the flat tire
and return the jack and tools to their
proper storage locations.
NOTICE
Check the tire pressure as soon as
possible after installing a spare tire.
Adjust it to the recommended pressure.
WARNING
Your vehicle has metric threads on the
studs and wheel nuts. During tire
changing, make sure that the wheel nuts
that were removed are reinstalled. If you
have to replace your wheel nuts, make
sure they have metric threads to avoid
damaging the studs and make sure the
wheel is properly secured to the hub. We
recommend that you contact an
authorized HYUNDAI dealer for
assistance.
If any of the equipment such as the jack,
wheel nuts, studs, or other equipment is
damaged or in poor condition, do not
attempt to change the tire and call for
assistance.
8
8-23